The versatility of Pneumatic excessive stress grouting pumps

Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the free rock mass. The maximum grain measurement can’t exceed 0.2 mm.
Grouting pump operation and maintenance is easy, protected and dependable. This pump is used in mines working underneath difficult circumstances because it’s dependable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it works
Pneumatic strain within the air cylinder exerts a high pressure on the grout combination which ends up in ejection of grout with a high stress and velocity. The valves of the air cylinder within the pump operate automatically to actuate the cylinder. Smuggled moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump may be driven even without Electrical power supply in remote areas by using engine driven compressor.
The pump is majorly used in construction and mining business for injecting materials into wide and medium measurement hole in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up etc. In mining trade it is used to fill up cement answer where there’s a hole exists between structure and rock and for soil stabilization.
Detachable design tends to simple maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly used in tunnels, coal mine, bridges and dams, constructing basis, and other underground projects, and inflammable, explosive websites and other unhealthy surroundings.
It has software in chemical business additionally to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any website condition whether or not it is rural or city.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the ultimate amount of the grouting volume is 8 or10 occasions of the amount in the beginning. And the final grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and flow could be adjusted in accordance with the necessities of grouting,(The circulate of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electrical energy, development, mining and so forth. ground/underground construction.
Mining Pneumatic Grouting pump has some nice advantages of low power consumption, small vibration, low noise, small measurement, excessive effectivity, reliable efficiency, pressure and circulate management, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can additionally be Light weight and with a wheelie design it can be carried easily. It is designed for simple operation and low maintenance. Last however not least its spare components are easily out there.

Leave a Comment